How to Install Wooden Floor Skirting
Oct 22, 2020|
View:1
How to Install Wooden Floor Skirting?
1. Drilling: before drilling, observe the wiring direction of water and electricity to prevent mistakes. The drilling interval should not be too large, otherwise, the wooden floor skirting is difficult to stick to the wall.
Drill holes in the wall with special tools. The common length of the wooden floor skirting is 2m. In order to fix the wooden floor skirting more firmly, the drilling interval should be about 40cm, and the interval at the interface should be smaller.
Pin a small piece of wood into the hole just made. The nail for fixing the wooden floor skirting is nailed on this wooden strip. If it is directly nailed on the wall, the nail is easy to loosen.
Note: as the pipe of the hydropower project is buried on the wall, the position of the pipe is directly below the switch socket. When drilling, the position should be calculated to avoid damage.
2. Fixation: before fixing the wooden floor skirting, the wall surface should be leveled and cleaned, otherwise, after the wooden floor skirting is installed, it can not completely adhere to the wall, leaving ugly gaps.
See the location of the drill hole, and then fix the nail to the wooden floor skirting. When fixing, attention should be paid to whether the wooden floor skirting is close to the wall surface, and the nails should be completely hidden in the wooden floor skirting, which can not be seen.
Note: the wooden floor skirting made of polymer, density board, and wood has the characteristics of thermal expansion and cold contraction. Therefore, the wooden floor skirting close to the wall corner should also be like the floor, leaving about a 1cm expansion joint.
3. Corner treatment: at the corner of the wall, where the wooden floor skirting intersects, the edge of the wooden floor skirting should be cut at a 45-degree angle so that the interface will not leave ugly marks. Fix the cut wooden floor skirting. Note: the wooden floor skirting of the corner must be cut at a 45-degree angle before splicing and installation, otherwise it will affect the beauty.
4. Installation points: the nail fixing the wooden floor skirting should use a special screw nail, which has a better fixing effect and is not easy to loosen. We should pay attention to whether manufacturers cut corners.
The wooden floor skirting is originally to cover the expansion joints of the floor and make the ground more beautiful. Therefore, the edge where the wooden floor skirting intersects should be scraped with a plane.
The wooden floor skirting should be completely close to the wall without leaving any gap, which is more beautiful, especially the corner. The flatness of the wall should be tested before installation.
